• oztrin
    link
    fedilink
    English
    arrow-up
    5
    ·
    3 months ago

    So one of the things I found out while cleaning out the garage was that my old childhood teddy had been left out there - and of course in a spot where it leaked 😖.
    A soak and then a run through the washing machine on a gentle cycle didn’t shift the dirt, so I tried putting him in another pillowcase and running the normal cycle - which got the dirt out but also half the stuffing.
    Any suggestions for repairs? I seem to remember there was a discussion recently about it.

    • CEOofmyhouse56
      link
      fedilink
      arrow-up
      4
      ·
      3 months ago

      You can try and work out where the hole is and re-stuff him then sew him up.

      • Seagoon_OP
        link
        fedilink
        arrow-up
        3
        ·
        3 months ago

        There will youtube videos that show what to use an how to stuff teddy bears .

    • melbaboutown
      link
      fedilink
      arrow-up
      4
      ·
      edit-2
      3 months ago

      Here’s a good guide. https://www.instructables.com/Stuffed-Animal-Restoration/

      However a seam ripper might be safer than an exacto knife if you have one. Pick a relatively straight/flat seam to open just to make it easy on yourself when closing him back up. I’d also recommend not wringing his skin out but rolling it in a towel and pressing that under a book to remove water, and then air drying. (Wringing can stretch out fabric and dryers can cause shrinkage or permanent shiny spots where the faux fur got flat ironed against the hot drum.)

      If you feel a bit out of your depth or don’t want to take your chances you can take him to the Doll Hospital https://thedollhospital.com.au/