This one’s fairly simple, it’s basically square cushions on top of a wood frame, for both the seat and back. There is no shaping or any fabric attached to the frame.
The only complication is that the seat base is done with tension springs attached to a metal frame that don’t seem to exist as replacement parts - I have found one supplier with something similar, but they don’t stock the right length. I’m going to use elastic webbing instead, which I’m at least familiar with using from previous projects, although I’ve not done anything larger than a dining chair.
I’m mostly a bit nervous about getting the piping on the cushions right. There was someone in the sewing sub on reddit that posted their project the other day which was almost identical, with links to a YT video they used and recommended so I will watch that one.
I’ve done sofa cushions. If making self piping make sure the piping cord is very loose so it doesn’t twist and so it bends easily, inside the tube, double stitch the corners with small stitches and cut the corners so they bend
are you making your own bias binding? Make the binding at least 5 cm wide
if buying sew in cord same goes, have it loose so it doesn’t twist or bend, double sew corners and snip the corners
Watch as many videos on YT about re-upholstering as you can
and good luck
I suggest taking lots of photos while you deconstruct the old upholstery and wearing strong tradie gloves
This one’s fairly simple, it’s basically square cushions on top of a wood frame, for both the seat and back. There is no shaping or any fabric attached to the frame.
The only complication is that the seat base is done with tension springs attached to a metal frame that don’t seem to exist as replacement parts - I have found one supplier with something similar, but they don’t stock the right length. I’m going to use elastic webbing instead, which I’m at least familiar with using from previous projects, although I’ve not done anything larger than a dining chair.
I’m mostly a bit nervous about getting the piping on the cushions right. There was someone in the sewing sub on reddit that posted their project the other day which was almost identical, with links to a YT video they used and recommended so I will watch that one.
I’ve done sofa cushions. If making self piping make sure the piping cord is very loose so it doesn’t twist and so it bends easily, inside the tube, double stitch the corners with small stitches and cut the corners so they bend
are you making your own bias binding? Make the binding at least 5 cm wide
if buying sew in cord same goes, have it loose so it doesn’t twist or bend, double sew corners and snip the corners