For your consideration, I submit my design for a new ASME standard. The Scaling Banana.

  • KingJalopy @lemm.ee
    link
    fedilink
    English
    arrow-up
    7
    ·
    7 days ago

    I would like to see the fixture holding that in place for each op in the machining process. I reckon you cut outside curve from a block then tapped the curve and operation 2 was held by a single bolt from underneath?

      • KingJalopy @lemm.ee
        link
        fedilink
        English
        arrow-up
        3
        ·
        7 days ago

        Damn that’s pretty smart! I used to work P&D in the aerospace industry mostly designing tooling and working out new programs in vericut. I like your approach! Nice work!

        • Bad_Engineering@fedia.io
          cake
          OP
          link
          fedilink
          arrow-up
          4
          ·
          7 days ago

          @[email protected] thanks. The fixture wasn’t initially planned for, but the last pass on the roughing cut for the front went too deep and thinned the tabs holding it in the billet a little too much for comfort. So I just used the cad file to make a negative that I cut into the wood. The Scaling Banana™ fits quite snuggly into the fixture, the grey silicone was just to keep it from lifting out during machining.

          • KingJalopy @lemm.ee
            link
            fedilink
            English
            arrow-up
            3
            ·
            7 days ago

            I didn’t even consider tabs when I first looked at it. We were discouraged from doing that at my job simply because too many button pushers worked there and could easily mess stuff up lol. We generally had them only roughing and the finish was always an actually machinist lol.

            • Bad_Engineering@fedia.io
              cake
              OP
              link
              fedilink
              arrow-up
              3
              ·
              7 days ago

              @[email protected] I’m not an actual machinist, just self taught. Also my machine isn’t particularly nice/precise. It’s an 90s bridgeport with a 3 axis cnc kit. So I try and use whatever tricks I can to make it all work out.

  • MisterFrog@lemmy.worldM
    link
    fedilink
    English
    arrow-up
    2
    ·
    6 days ago

    Lemmy is so blessed to have this certified top-tier content.

    This is so beautiful.

    Other than the fact Australia will adopt it and I’ll be left using nominal banana sizes based on the US banana.

  • givesomefucks@lemmy.world
    link
    fedilink
    English
    arrow-up
    5
    arrow-down
    4
    ·
    7 days ago

    Bananas are a measurement of radiation…

    So, this ignores the actual science behind a joke and only cares about the meme without understanding it.

    Very apt name, because engineers are the only ones who would know and care about it.