Fewer than three weeks before actor Alec Baldwin is due to go on trial in Santa Fe, New Mexico, prosecutors have said that he “engaged in horseplay with the revolver”, including firing a blank round at a crew member on the set of Rust before the tragic accident occurred.

Baldwin is facing involuntary manslaughter charges in the 2021 shooting death of cinematographer Halyna Hutchins.

In new court documents, prosecutors said they plan to bring new evidence to support their case that the 66-year-old actor and producer was reckless with firearms while filming on the set and displayed “erratic and aggressive behavior during the filming” that created potential safety concerns.

Prosecutors in the case, which is due to go to trial on 10 July, have previously alleged that to watch Baldwin’s conduct on the set of Rust “is to witness a man who has absolutely no control of his own emotions and absolutely no concern for how his conduct affects those around him”.

In the latest filing, special prosecutors Kari Morrissey and Erlinda Johnson allege that Baldwin pointed his gun and fired “a blank round at a crew member while using that crew member as a line of site as his perceived target”.

  • Chozo@fedia.io
    link
    fedilink
    arrow-up
    1
    ·
    7 days ago

    Real, sure. But functional, no. Sometimes, for authenticity’s sake or just for cost reasons, it may make sense to use a real firearm for a scene. However, it should always be modified so that it cannot be loaded or fired. There are plenty of ways to do this without affecting the appearance of the gun, and skipping that is just pure negligence.

    • AngryCommieKender@lemmy.world
      link
      fedilink
      arrow-up
      0
      ·
      7 days ago

      Unless it’s a revolver, just remove the firing pin. Problem solved. Revolver might be a little more tricky, but removing the pin from the hammer and putting a silicone cushion into the chambers should work.

      • ArcaneSlime@lemmy.dbzer0.com
        link
        fedilink
        arrow-up
        0
        ·
        7 days ago

        The colt SAA and other old revolvers’ firing pin was attached to the hammer (at least most of the newer repros have updated that part for safety). That is why they used to carry them on an empty chamber, because otherwise your firing pin would just be resting on the primer and could very easily go off if bumped. If using a repro you could similarly just remove the firing pin, if using an original (just don’t do that, because what I’m about to say is an affront to history, but) you could grind that pin down enough that it’d never make contact with the primer again. Shudder.