Any most have upgrades for a mostly stock Ender 3 running on a 8-bit board with an original bed? Changed out bed springs and tube already.

  • deFrisselle@lemmy.sdf.orgEnglish
    4·
    11 months ago

    Octoprint if you can get an Rpi Stock is improving and it’s a great addon It’s also nice to be able to send prints right from the slicer

    • greenbean@lemmy.mlEnglish
      3·
      11 months ago

      The best upgrade I made. No more moving SD cards back and forth. Adding a camera and octo everywhere takes it to another level too. I also bought a little USB light from ikea and plugged it into the raspberry pi, very useful when printing in a dark room.

    • PdeT@feddit.nlEnglish
      2·
      11 months ago

      Just to note, you don’t need a Pi to run Octoprint. I used Octoprint Deploy to run it on a LePotato and it runs like a charm.

      • deFrisselle@lemmy.sdf.orgEnglish
        2·
        11 months ago

        That’s a good option I’ve seen quite a few using the LePotato for Octoprint and Klipper I’m just glad I got a few Rpi before they dried up