• WhyIsItReal@lemmy.world
    link
    fedilink
    arrow-up
    3
    arrow-down
    1
    ·
    1 year ago

    sure you can, you say “i need a hole with diameter 0.25” ± 0.015625“”. it doesn’t matter that you have more sig figs when you state your precision

    but regardless, that’s probably not the precision you care about. there’s a good chance that you actually want something totally different, like 0.25±0.1”. with decimal, it’s exceptionally clear what that means, even for complicated/very small decimals. doing the same thing fractionally has to be written as 1/4±1/10”, meaning you have to figure out what that range of values are (7/20” to 3/20”)

    • chiliedogg@lemmy.world
      link
      fedilink
      arrow-up
      2
      arrow-down
      4
      ·
      1 year ago

      Having to provide a “+/-” for a measurement is a silly alternative to using a measurement that already includes precision. You’re just so used to doing things a stupid way that you don’t see it.

      • WhyIsItReal@lemmy.world
        link
        fedilink
        arrow-up
        3
        arrow-down
        1
        ·
        1 year ago

        providing an arbitrarily non-reduced fraction is an even sillier alternative. the same fundamental issue arises either way, and it’s much clearer to use obvious semantics that everyone can understand

        • chiliedogg@lemmy.world
          link
          fedilink
          arrow-up
          1
          arrow-down
          2
          ·
          1 year ago

          It’s not the same issue at all.

          How do you represent 1/64th in decimal without implying greater or lesser precision? Or 1/3rd? Or 1/2 or literally anything that isn’t a power of 10?

          You’re defending the practice of saying “this number, but maybe not because we can’t actually measure that precisely, so here’s some more numbers you can use to figure out how precise or measurements are”

          How is that a more elegant solution than simply having the precision recorded in a single rational measurement?