• KingOfTheCouch@lemmy.ca
    link
    fedilink
    arrow-up
    65
    arrow-down
    1
    ·
    9 months ago

    Growing up we had a walk in shower, the way it was setup there was no way to reach in and not get hit by cold water. Especially a short kid with short arms, you were getting a full blast cold water trying to go “out” of the shower. The tap was the push-pull type and very difficult to modulate so limiting to low pressure trickle was basically a game of russian roulette. The best I could do was hug the wall and let it only get whatever corner of my body I wanted to sacrifice to temporary hypothermia that morning.

    • LemmyKnowsBest@lemmy.world
      link
      fedilink
      arrow-up
      18
      ·
      9 months ago

      some people have posted photos of showers in modern upscale hotels, walk-in showers that have a hole through the glass for you to stand safe & warm & dry outside, reach through the hole from the outside to turn on the water.

      • gazter
        link
        fedilink
        arrow-up
        22
        arrow-down
        1
        ·
        9 months ago

        This just seems like the wrong way around… Surely it’s better to build the shower so the water doesn’t go near the tap? Just have the tap off to the side?

        Imagine having a sink where the tap was directly underneath the spout.

          • Rodeo@lemmy.ca
            link
            fedilink
            arrow-up
            4
            ·
            9 months ago

            That’s an understatement. It would be such a huge pain the ass to plumb that.

            • Krauerking@lemy.lol
              link
              fedilink
              arrow-up
              1
              ·
              9 months ago

              Yeah that was definitely a take that forgets that valves are still a mechanical system and the knobs are where they are cause they open and close the flow of water there. I guess you could do electrical systems now but… That’s probably a bad idea for so many reasons.

              • gazter
                link
                fedilink
                arrow-up
                1
                ·
                9 months ago

                Yes, the plumber would have to put a few extra bends in the pipe, drill through a couple more studs. I don’t see that as being a big deal. It’s a pretty common thing to see taps that are not directly in line with the shower head.

      • Peppycito@sh.itjust.works
        link
        fedilink
        arrow-up
        7
        ·
        9 months ago

        My friends house had a little spout near the floor in his stand up shower, so you could run the water and test the temperature with your toe. When it was good you pulled the stopper like in a bath and it came out of the shower head.

        • merc@sh.itjust.works
          link
          fedilink
          arrow-up
          2
          ·
          9 months ago

          And all the cold water that has been sitting in the shower pipes since the last shower comes out, pushed by the warm water behind it.

    • RampantParanoia2365@lemmy.world
      link
      fedilink
      arrow-up
      16
      ·
      9 months ago

      My aunt and uncle had a walk in where the controls were by the door instead of under the shower head. I always thought that was brilliant.

    • LifeOfChance@lemmy.world
      link
      fedilink
      arrow-up
      4
      ·
      9 months ago

      This would honestly be a reasonable enough excuse on why the OP was set in his ways from something like this. Once you’re conditioned to something it takes a hold on you. How often does a person really question a habit they learned at a really early age?

      • KingOfTheCouch@lemmy.ca
        link
        fedilink
        arrow-up
        3
        ·
        9 months ago

        Oh yeah, this was the solution later on. For like kid me? At the time I didn’t know you could even replace the showerhead… :(