First time printing with TPU. Another problem I had was that it didn’t stick to the textured print bed, had to go for smooth PEI which I read (and now can confirm) is not ideal. Would satin be better?

  • tenzen@lemmy.ca
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I had similar messy results at one point – it tuned out to be a bad zOffset. Having said that, my part also as a messy top layer – not sure if yours has that or not with the little nub there.

    • Rikudou_Sage@lemmings.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      No, that nub is not on the head, it’s slightly beyond, this is due to the angle. The z offset works for PLA, I assume I don’t have to change it for TPU?