I’m running Cat6 and would like to use wall plates rather than just pulling the cables out of the walls and sticking a Cat6 plug on the end. I’m in the UK and all the walls are brick. Would I need to somehow carve out the bricks or is there some easier way to do it?

  • fediverser@alien.topEnglish
    1·
    7 months ago

    This post is an automated archive from a submission made on /r/HomeNetworking, powered by Fediverser software running on alien.top. Responses to this submission will not be seen by the original author until they claim ownership of their alien.top account. Please consider reaching out to them let them know about this post and help them migrate to Lemmy.

    Lemmy users: you are still very much encouraged to participate in the discussion. There are still many other subscribers on [email protected] that can benefit from your contribution and join in the conversation.

    Reddit users: you can also join the fediverse right away by getting by visiting https://portal.alien.top. If you are looking for a Reddit alternative made for and by an independent community, check out Fediverser.

  • TiggerLAS@alien.topBEnglish
    1·
    7 months ago

    Surface mount may be the way to go.

    You can get surface mount boxes with keystone jacks that point out the side. These will be reasonably low-profile.

    You could probably “rough up” the cover a bit with some sandpaper, and paint the cover of the box so that it blends in with the color of your bricks.

    If you install the surface mount so that the jack(s) themselves point towards the floor, it would naturally direct the cables downwards, while hiding the unpainted faces of the keystone jack from direct view.

    Additionally, you could choose dark-colored RJ45 keystone jacks, such as black, dark red, or grey, rather than using the more stark white or almond colors.