Someone on FB said it went from docsis3.1 to 3.0. the down light is supposed to be blue. Randomly moving the modem a certain way I can get it blue but only a few seconds. It’s also making my speeds almost dial up speeds. Is there a way to fix it?

  • Ariquitaun@alien.topB
    link
    fedilink
    English
    arrow-up
    2
    ·
    8 months ago

    If you move it and it changes behaviour, that’s some sort of bad mechanical contact. Cabling, socket.

  • MISTERPUG51@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    8 months ago

    If the it’s connected with coax, make sure the cable is screwed all the way in. I doubt turning it off and back on won’t do anything, but it doesn’t hurt to try

  • TiggerLAS@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    8 months ago

    If you have a spare coax cable that you can use for testing (even if it is a short one), try swapping it out, and see if your blue lights come back on.

    I’ve had borderline / intermittent coax cables in the past.

      • Optimus02357@alien.topB
        link
        fedilink
        English
        arrow-up
        0
        ·
        8 months ago

        The levels look good although you are missing some downstream and upstream channels. Should be 32x4 at least. Do the signal levels change when you move the modem? Also, what part are you moving? Sounds like a broken coaxial port on the modem to me or something like that.

    • fizdog@alien.topOPB
      link
      fedilink
      English
      arrow-up
      1
      ·
      8 months ago

      I’ve tried everything from unplugging it for 60 seconds. Resetting it by that small reset hole to replacing the coax cable. Talked to the ISP they did some resets on their end. Nothing. So they scheduled a tech to come out and take a look.

      Had this happen awhile ago where a reset fixed it but this time my speeds barely get over 1Mbps and a simple reset doesn’t do anything.

  • fizdog@alien.topOPB
    link
    fedilink
    English
    arrow-up
    1
    ·
    8 months ago

    My ISP did tell me today that there was an outage and that they are working quickly to “fix” it but if they aren’t in the area “fixing” it where would they be fixing it?

  • SimplBiscuit@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    8 months ago

    It should be blue if it’s bonded with all carriers to make docsis 3.1. Could be the modem could also be a RF issue assuming you’re in a HFC network.

  • yourMommaKnow@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    8 months ago

    Flashing On Not applicable — icon does not flash. Green: Power is properly connected. Scanning for a downstream (receive) channel Internet connection. Green: Downstream channel is connected in DOCSIS 3.0 mode. Blue : High-speed Internet connection with downstream channels in DOCSIS 3.1 mode. Scanning for an upstream (send) channel Internet connection. Green: Upstream channel is connected in DOCSIS 3.0 mode. Blue: High-speed Internet connection with upstream channels in DOCSIS 3.1 mode. Scanning for an Internet connection. Green: Cable modem is connected to the Internet. *Blue - Indicates DOCSIS 3.1 operation (high-speed Internet access) which may not be available in all locations. Check with your service provider for availability in your area

    • fizdog@alien.topOPB
      link
      fedilink
      English
      arrow-up
      1
      ·
      8 months ago

      It’s just a modem that I bought myself cause I upgraded my plan with my ISP to 1gb and the modem they provided couldn’t do those speed. But the modem does have a login page and says there was a SW upgrade that failed in the logs

      • Taleya
        link
        fedilink
        English
        arrow-up
        1
        ·
        8 months ago

        Double check your model. I have an Arris, all four green is what i want to see. Flashing is an error/synching

  • deefop@alien.topB
    link
    fedilink
    English
    arrow-up
    1
    ·
    8 months ago

    If you’ve already doubled checked the coax connections being nice and tight, call your isp. It’s almost certainly a signal level issue or something else on their end.

  • TomRILReddit@alien.topB
    link
    fedilink
    English
    arrow-up
    0
    ·
    8 months ago

    Have you logged into the modem to check the error logs for reoccurring errors and also check the signal level screen for Uncorrectables.