I’m thinking of making a dry box for my printer, however I have some questions:

  1. Will using PVC pipe as a “roller” (if that’s the right word) that I’ll place my filament spools on be good enough? Or do the spools need to go on something more concave? Maybe I can cut some grooves for the spools to sit in? I know there are dry boxes that use like holders that you screw in, but I want to limit the amount of holes in the box.

  2. Does filament have to be spaced or can I put the spools in the box to where there is no gaps but they can still move freely?

  3. Does it matter if I use M6 or M10 pneumatic couplers to feed the filmanet through or is it just personal preference?

  • bigredgiraffe@lemmy.worldEnglish
    2·
    1 year ago

    Yeah that is similar to what I was thinking but 4 individual sets of rollers, one for each spool. This version would be annoying in a drybox because all of the filament spools will probably spin at the same time which will make them all unspool since you will probably have them fed into 4 couplers and not clipped like on a shelf. Might work though if you don’t plan on having one output for each box and switching the “active” spool but I try to not open my dry boxes in general to keep air moisture out.

    • chrischryse@lemmy.worldOPEnglish
      1·
      1 year ago

      Ah thanks for the input…I didn’t think about all spools spinning the samed until you mentioned it so I just decided to print the individual rings that I would put the bearings in then I’m gonna put them on a metal rod.

      Also not sure you would know, would i be fine printing the bearings to use or should I get metal ones