Essentially the title.

If only S2 (previous connection point from light switch to bulb) is truly required, then, wow, that makes things way easier to install.

I guess electrically it makes sense, I’m just weirded out it does not show in the instructions.

    • unknowing8343@discuss.tchncs.deOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      edit-2
      1 year ago

      After some research, all I’ve gathered is one report saying that you’ll absolutely destroy the Sonoff if you try to do that.

      I reviewed the Aqara manual, and the possibility is specified there, so that makes it quite probable that it simply is a forbidden configuration for the Sonoff, or even any smart switch that does not specify that possibility.

      So, unless someone magically shows me it’s possible, I am avoiding it for now, I’ll learn how to pass cables through the tubes and avoid any burning for now 😅

      The reasoning behind the “it will NOT work” is that Sonoff uses S1 and S2 to create a low voltage circuit. It’s expecting low voltage, so it might break due to a voltage overload.

      • kittenbridgeasteroid@discuss.tchncs.de
        link
        fedilink
        English
        arrow-up
        1
        ·
        edit-2
        1 year ago

        S1 and S2 are only for the activation switch. You connect the actual device that gets controlled to Line Out.

        If your setup doesn’t require a physical switch, then nothing gets connected to S1 and S2