Hi, I’ve recently built myself my first server to host a minecraft server. I manage this server through cockpit, which isn’t port forwarded.
Now I’m going to move to a different place, but I want to keep that server at this house because of more stable internet and me moving to a smaller space, but I don’t know how I could access this server remotely.
I’ve already tried adding a vpn to my router, but when connected, I still can’t access my cockpit dashboard. Am I doing anything wrong or do I need to port forward to access my cockpit instance remotely?
Probably it would be much easier for you to setup tailscale. Just install it on the system you host the other services, install on the other end and use the tailscale ip. It should require minimal effort to set up with the added benefit of not having ports open, and way easier maintaining.
As for wireguard, the allowed up section tells what ips should be routed through the tunnel, it’s not that difficult, but hard to wrap your head around at first. A friend of mine also used to use the Fritzbox Implementation of wireguard and I remember you need to specifically setup what clients you want the tunnel to have access to.
Have a look at tailscale.
Thank you for the info! I’ll take a look at tailscale and try to wrap my head around the wireguard thing. Thanks for the help!
this.
There’s not a lot of information to go on here, but my first thought is that you haven’t configured your VPN to route to the local network. So, while you may be getting a connection to the VPN server, your computer doesn’t know where to send traffic for Cockpit.
There is usually a way to push those routes to the client from your con server.
Hi! I’ve done a bit more thorough googling, because of you I knew what to look for a bit better. I have a wireguard vpn on my fritz box router enabled, which allows me to connect to the vpn from my laptop.
I’ve read up on how to acces local devices and I found something about adding an IP to the “AllowedIPs” section, but I don’t really get which IP I should add.
The folks replying here have pretty much hit the nail on the head. Adding your home network to that AllowedIPs line in the confit file should do the trick.
Someone else mentioned Tailscale, which would be another great option—with a web UI to dial in routes.
It should be set to your local subnet, for example 192.168.1.0/24
While not what OP wants, this is what I want, but it isn’t working for me. I am trying expose a subnet behind nat, to a public server. I am currently testing this by attempting to expose the vlan created by libvirt on my laptop to my public vps. I followed the linked point to site guide, and ironically, the virtual machines created on my laptop can access the wireguard subnet, but public vps cannot access the virtual machines? (the guide said that it would be the opposite without the iptables nat/masquerade rules) I am guessing because I am doing this somewhat backwards, where the device exposing the lan is behind nat, whereas it is the other way around in the guides that I have seen.
This would tell the peer with this configuration to send all traffic for the whole 192.168.1.0/24 through the tunnel, not sure that is what OP wants. (Didn’t look at the link though)
Would probably setup something like Pivpn on the server and port forward it
Acronyms, initialisms, abbreviations, contractions, and other phrases which expand to something larger, that I’ve seen in this thread:
Fewer Letters More Letters IP Internet Protocol SSD Solid State Drive mass storage VPN Virtual Private Network
3 acronyms in this thread; the most compressed thread commented on today has 6 acronyms.
[Thread #49 for this sub, first seen 16th Aug 2023, 05:25] [FAQ] [Full list] [Contact] [Source code]
