• magicmellon@lemmy.world
    link
    fedilink
    English
    arrow-up
    18
    ·
    edit-2
    1 year ago

    This could be “Die Swell” where something that’s cold extruded through a nozzle swells in size after it comes out the nozzle. While this is definitely an extreme example it is possible to get 2x expansion.

    Check your temps and the temps of the new material.

    Edit: are you sure you just haven’t bought some 3mm filament as the picture doesn’t look extruded, it looks like those are filament off the roll.

    • Fisk400@feddit.nuOP
      link
      fedilink
      English
      arrow-up
      5
      ·
      1 year ago

      They look like they are off the roll because it’s from when you load the filament. The top one is 0.6mm and the bottom is 1.2mm and both are from 1.75mm filament trough a 0.4 nozzle at 230.

      It could be that the glossy filament expands when it is run too hot? When you print normally with it, it doesn’t expand the same way. It’s still messier than other filaments when printing details tough.

      • ShadowRam@kbin.social
        link
        fedilink
        arrow-up
        1
        ·
        1 year ago

        wait, what?

        You’ve extruded into air through a 0.4 nozzle and you got 0.6mm worth of die swell?? That seems excessive for any filament type.
        What speed did you extrude that at?

        There’s just no way I could believe you could extrude into thin air through a 0.4 nozzle and end up with 1.2mm worth of swell of any material, unless it was going through an actual chemical reaction.

        Something that expands THAT much after extruding would leave a monumental mess.